Pinagem
Pinagem Sensor de temperatura DS18B20 (1-Wire, TO-92)
Pinos
- GND
- DQ (1-Wire data — needs a 4.7kΩ pull-up resistor to VDD)
- VDD (3–5.5V — or tie to GND for parasitic-power mode, with DQ then supplying the chip through a strong pull-up)
Especificações
| Tensão de alimentação | 3.0–5.5 V (or parasite power from DQ) |
|---|---|
| Interface | 1-Wire, unique 64-bit ROM code per sensor |
| Pull-up on DQ | 4.7 kΩ to VDD |
| Measuring range | −55–125 °C |
| Accuracy | ±0.5 °C from −10 to 85 °C |
| Resolution | 9–12 bit (0.5–0.0625 °C), selectable |
| Conversion time | 750 ms max at 12 bit (94 ms at 9 bit) |
| Active current | 1 mA typical (1.5 mA max) |
| Standby current | 750 nA typical |
| Encapsulamento | TO-92 (also waterproof probe) |
Notas
- Pin order is GND, DQ, VDD left to right with the FLAT, marked face towards you and the legs pointing down. Swapping VDD and GND makes the chip heat up within seconds and usually kills it — check the flat face before powering.
- The waterproof probe version is the same chip in a steel sleeve on a cable: red = VDD, black = GND, yellow (or white/blue) = DQ.
